Ford Explorers, no matter which year, model or choice package deal, all have one thing in widespread: the need for a functioning starter motor. The Starter Motor meeting contains an electrical motor, which ejects a gear from the nose of the starter. This gear, known as a bendix, contacts the engine flywheel and then spins it, which helps the engine flip over and start. If the electric motor or bendix fail to carry up their finish of the discount, you’ll have to put in a Starter Motor that capabilities properly.
Ford Explorer Starter Motor Installation Instructions
1. Remove the unfavorable battery cable type the battery using the battery wrench. Push the cable away from the battery so it can not contact the battery throughout the repair.
2. Lift the proper-front nook of the Explorer with the ground jack. Help it on one jack stand, positioned at the jack level alongside the passenger side body rail, just behind the suitable-entrance tire.
3. Climb below the right front of the Explorer with the opposite jack stand and the socket set. Remove the wiring harness and floor strap from the back facet of the starter with the socket set. You may find the starter on the side of the engine, where the transmission bell housing bolts to the back of the engine block.
4. Assist the physique of the starter with the jack stand and take away the starter mounting bolts with the socket set.
5. Pull the starter out from underneath the Explorer and set it aside. Put the alternative starter in place, resting it on the jack stand, and thread the mounting bolts in place by hand. Tighten the bolts with the socket set.
6. Reattach the starter wiring and ground strap in reverse of how you eliminated them. Climb out with the jack stand after which lower the Explorer off the opposite jack stand with the floor jack.
7. Reconnect the destructive battery cable to the battery. Return the previous starter, in the alternative starter’s packaging, to the place of purchase for a refund in your core charge.